24
(I)
-
Fix
the speaker wires with some glue and trim them to a length of 20cm
-
Slide an insulating sleeve over both wires. Solder a connector to both
wires and slide the insulating sleeves over the connector.
-
Fix the 4 plastic feet by means of a 23mm screw and put the enclosure
on its feet.
(J)
-
put the heatsink in place and mark the 10 holes.
-
remove the heatsink
-
pre-drill the holes with a 1.5mm drill
-
connect the red speaker wire to the connector marked 'LS+'
-
connect the black speaker wire to the connector marked 'LS-'
-
Carefully put the amplifier module in place.
-
Fix the heatsink using ten 10mm black screws
Enclosure assembly
Summary of Contents for K8077
Page 28: ...28 PCB 35 PCB...
