9
Close the enclosure with the 2 supplied screws.
Drill two Ø3mm holes in the housing according to figure 1.0.
The RCA cable will run through them.
Solder the signal wires or the RCA
cable to the 'OUT' terminal on the PCB
(see figure 2.0).
Solder the shielding of the RCA cable
to the 'GND' terminal on the PCB (see
figure 2.0).
19. Assembly
Assembly
3mm drill.
Fig. 1.0
Fig. 2.0
shielding
signal
GN
D
