VDPSP151
1 VELLEMAN
VDPSP151 – 4-CHANNEL ANALOGUE POWER PACK (4 x 6.3A)
1. Introduction & Features
Thank you for buying the
VDPSP151
! It features 4 channels with LED indication controlled by analogue input, whilst
also providing a power supply for an analogue controller. Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, contact your dealer and postpone installation of the device.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
•
A qualified technician should install, connect and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
•
This device falls under protection class I. It is therefore essential that the device be earthed.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
•
Note that damage caused by user modifications to the device are not covered by the warranty.
•
Keep the device away from children and unauthorised users.
3. General Guidelines
•
This device is designed for professional use on stage, in discos, theatres, etc. The
VDPSP151
should only be
used indoors with an alternating current of max. 230V AC/50Hz.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device is protected against extreme temperatures, dust and moisture.
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Removal of the serial number sticker will void the warranty.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
1. Switch off the circuit breaker at the back of the device.
2. Connect the analogue controller to the device with an 8-
pin cable. Put the output of the controller to a minimum.
3. Connect the load to the SHUCKO output sockets.
4. When all connections are established, plug the device
onto the mains and switch on the circuit breaker.
5. Adjust the load on the selected channel by means of the
output of the analogue controller.
