HAMGSM133
15/12/2011
©
Velleman nv
8
configuration SMS.
With the same phone used to make the first setup call, it is also possible to switch the relay
status.
Through SMS
This mode takes full advantage of the device with operations as output switch, output status
query, inclusion of additional phone numbers to activate the relay, inclusion of numbers for
door opening function, reception of reply messages; change output signals timing and, in
general, set the
HAMGSM133
with all parameters via simple SMS. A full reset to restore the
default settings can also be made via SMS. The syntax for all available commands can be
found in
§8 Configuration SMS
.
Through USB (USB interface required, not incl.)
This mode easily allows you to setup the
HAMGSM133
through a computer (with special
software) connected via an USB interface (not incl., Ref.
HAMGSM133/USB
).
It is possible to manage all programming and settings as well as change the list of enabled users.
This speeds up the initial set-up and saves on the cost of SMS. After starting the software,
verify that the communication speed is set to 9600 Baud (8, N, 1).
Refer to the full user manual for more information on the installation and use of the software.
Download the (English) software from
www.velleman.be
9.
Configuration SMS
Commands and settings can be sent from any mobile phone as long as the message includes the
password.
For some commands a password is not required when the message was sent from a telephone
number which is stored in the
HAMGSM133
. However, some commands that change critical
information always require a password.
The
HAMGSM133
replies with a confirmation or information SMS.
Multiple commands can be combined in 1 SMS by placing a comma in between.
Note:
commands
never
contain spaces.
Refer to overview of all configuration SMS commands below.
Change password
(password
required)
Command:
PWDxxxxx;pwd
xxxxx = new password (5 digits)
pwd = current password (default = 12345)
Example:
PWD54321;12345
Store numbers
(password required for overwrite or from unknown phone)
Command:
NUMx+YYnnnnnnnnnn;pwd
YY = country code
x = position of the number in the list (1~8)
nnnnnnnnnn = phone number (max. 19 digits)
pwd = current password (default = 12345)
Example:
NUM7+324851234567;12345
324851234567 is stored on location 7 in the master list.
Remove numbers
(password
required)
Command:
NUMx;pwd
x = position of the number in the list (1~8)
pwd = current password (default = 12345)
Example:
NUM5;12345
The number on location 5 is removed from the master list.
List stored numbers
(password
required)
Command:
NUM?;pwd
pwd = current password (default = 12345)
Example:
NUM?;12345
Show the master list.
