ECAMIP701
·
Quick Start Guide
4)
Secure the bubble to the speed dome with three screws as shown in Figure 2-7.
Screws
Figure 2-7
Secure the Bubble
6.
Route the cables through the ceiling.
7.
Remove the protective film on the bubble after the installation is finished.
2.2
Installing N4xxxI Series (IR) Speed Dome
2.2.1
Wall Mounting
Notes:
⚫
For cement wall, you need to use the expansion screw to fix the bracket. The
mounting hole of the expansion pipe on the wall should align with the mounting
hole on the bracket.
⚫
For wooden wall, you can just use the self-tapping screw to fix the bracket.
⚫
Make sure that the wall is strong enough to withstand more than eight times the
weight of the speed dome and the accessories.
⚫
The bracket in Figure 2-9 is the recommended bracket for this series of speed dome,
and a pendent adapter is required if any other bracket is selected. The dimension of
pendant adapter is G1
1
2
.
Steps:
1.
Install the memory card.
1)
Loosen the lock screws on the rear cover and remove the rear cover.
2)
Align the memory card with the memory card slot and insert it.
Summary of Contents for EtiamPro ECAMIP701
Page 1: ......
