DVM890 GB
8
5. Accessories
•
set of test leads
•
K-type thermocouple (400°C)
•
1 battery of 9V
•
1 user manual
•
1 holster
•
1 adapter for capacitance measurements
5.1. How to use the holster
The holster protects the device and ensures comfortable operation. Consult the figures below :
1. Use one of the two supports to place the device on a table or a desk (fig. A & B).
2. Hang the meter on the wall using the smaller of the two supports. (fig. C) : remove the
smaller support and insert it in the slots at the top of the holster. Use the support to hang the
device on a nail in the wall.
3. Each of the two supports in fig. D can hold a test lead.
6. Replacing the Battery and the Fuse
The "
" symbol appears when the battery needs to be replaced. Proceed as follows :
1. Disconnect the test leads from all live sources, switch off the device and remove the test
leads from the input terminals BEFORE opening the housing. This is necessary in order to
avoid the risk of electroshocks.
2. Remove the screws in the back cover and retrieve the battery.
3. Insert a new 9V-battery (NEDA1604 or IEC6F22).
4. Replace the cover and tighten the screws.
The fuse rarely needs to be replaced and a blown fuse is nearly always due to an error on
behalf of the operator. Open the housing (see above) and replace the blown fuse with an
identical one : F : F 0.2A/250V.
