CAMIP1
1
VELLEMAN
CAMIP1 – NETWORK CAMERA
1. Introduction & Features
Thank you for buying the
CAMIP1
! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
The
CAMIP1
is a stand-alone network camera that enables you to view live, full motion video from anywhere in the
world using a standard web browser. It features a built-in web server, so it needs not to be connected to a pc. The
CAMIP1
comes with a RJ-45 cable (cross-link) and a 5Vdc 2A adapter.
2. Technical Specifications
Required hardware 32bit RISC CPU, 16M RAM, 2MB Flash
Development OS
Linux
Required OS
Windows
Protocol
HTTP / TCP/IP / UDP / RARP / PING / ARP / DHCP / BOOTP / PPPoE
Image compression Motion JPEG
Sensor
1/3" CMOS, 330K pixels
Resolution
640x480 / 320x240
Frame Rate
VGA: 10 fps / CIF: 25 fps
Lens
Fixed lens, manual focus 25cm~infinity, aperture F1.8, focal length 4.0mm
Image Control
Brightness, Contrast, Hue
Shutter
1/60 ~ 1/15000s
Min. illumination
5.0Lux @ F1.8
I'net Browser
IE5.0 or Above (ActiveX) / Netscape6.0 or Above (Java)
Security
Password protection
Multiple users
max. 8
Snap-Shot
yes
yes
Firmware Update
Online
3. Installation
a. Hardware Installation
1. Connect the
CAMIP1
to your pc by means of a RJ-45 cable (crosslink cable).
2. Power the
CAMIP1
and the pc on.
Windows OS is needed to setup the real IP address. After the setup, connect the
CAMIP1
to the network with a
standard RJ-45 cable to view the images through Internet.
b. Software setup
1. Open your internet browser and set as IP address: 172.20.1.100 (default IP)
Note: You should also go to “Internet Protocol (TCP/IP) Properties” to setup the appropriate IP address.
For example: IP address
: 172.20.1.200
Subnet mask
: 255.255.0.0
Default gateway : 172.20.1.254
2. A pop-up dialog appears ; enter the
CAMIP1
default User name and Password.
User name : root
Password : admin
(or your own user name and password when available)
