CAMCO LVC23
V. 02 – 27/05/2014
10
©Velleman nv
10.
Remote Control
Make sure the remote control contains a battery.
•
Point the remote to the infrared eye on the camera.
•
The remote has the following buttons
o
Power: turns off the camera.
o
Snap: takes a picture.
o
Video: records video.
11.
Waterproof Housing
The camera comes with a waterproof housing. It is recommended to
test the housing without the camera before use.
•
Before sealing the waterproof case, make sure the camera
housing’s rubber seal is clean. A single hair or grain of sand can
cause a leak. You can test the housing by closing the case without
inserting the camera. Submerse the case completely in water for
about a minute. Remove the case from the water, dry off its
exterior with a towel, then open the case. If the entire interior is
dry, the case is safe for use under water.
•
Remember to put the camera in the desired mode before inserting
the camera in the waterproof case. There is no external button to
change the camera mode.
•
After every use in salt water, you will need to rinse the outside of
the housing with non-salt water and dry it. Not doing this can
eventually cause corrosion of the hinge pin and salt build-up in the
seal, which can cause failure.
•
To clean the seal, rinse in fresh water and shake dry. Drying the
seal with a cloth may cause the seal to leak. Re-install the seal
into the grooves in the backdoor of the housing.
12.
Cleaning and Maintenance
Battery
WARNING
•
Do not puncture or throw batteries in fire as they
might explode.
•
Keep batteries away from children.
This device contains an internal, non-removable,
rechargeable battery. When the device is end-of-life, it
must be disposed of in accordance with local regulations.
