![background image](http://html.mh-extra.com/html/velleman/camcolbul18/camcolbul18_user-manual_861709004.webp)
CAMCOLBUL18
25/03/2009
©2008
Velleman
®
Components nv
4
4.
Installation
Refer to the illustration on page 2 of this manual.
•
Choose the location for the dome camera, keeping following guidelines in
mind:
•
Do not install the camera in locations where extremely high or low
temperatures, high humidity, water vapour or steam, dust or excessive
vibrations may occur.
•
Avoid mounting the camera near high electro-magnetic fields as this will
influence image quality.
•
Do not aim the camera at the sun or other extremely bright objects or
reflections.
•
Best mounting height: at least 2m20.
•
Use the included hex key to unscrew both base hex head screws
[5]
(one
on either side of the base) until the camera can rotate versus the base.
Do
not
remove the screws completely.
•
Rotate the camera while pulling base and camera apart. When internal
protrusions (hex screw) and slots line up, the camera can be removed from
its base.
•
Use the base to determine the mounting holes. Make sure to guide the
cables through the base before mounting it on the wall or ceiling.
•
Line up protrusions (hex screws) from the camera with the slots in the base
and place the camera back on the base. Rotate the camera to secure it. Do
not tighten the base screws
[5]
yet.
•
Unscrew lens screws
[6]
(one on either side of the camera) until the lens
can rotate versus the camera body.
Do not
remove the screws completely.
•
Point the camera towards the detection area and connect it to a security
system (not included).
•
Tighten both base hex screws
[5]
until the camera can not rotate versus
the base anymore.
Do not force
to avoid deformation of or damage to the
housing.
•
Rotate the lens until the received image is upright, than tighten both hex
screws
[6]
until the camera can not rotate versus the camera body
anymore.
Do not force
to avoid deformation of or damage to the housing.
5.
Useful information
•
IR LEDs
[4]
are automatically activated when environmental light
conditions are lower than 8 lux.
•
Motion detection is based on light and image changes. Avoid placing the
camera in places with frequent changes in light (e.g. streets).
•
White LEDs are activated at night time (IR ON) when motion is detected,
thus providing colour images at night. They stay active for 15 seconds
after last motion detection. When activated, IR LEDs are off.