__________________________________________________________________________________________________________________________________________________________
3
ASSEMBLY STEPS
Required tools to assemble the kit:
Use a small soldering iron of max. 40W.
Use thin (1mm) solder, do not use any flux.
Use a small cutter to trim the excess wires.
1
.
2
.
3.
4.
Mount the compo-
nents against the
PCB surface and
carefully solder the
leads in place.
Obtain cone- shaped,
shiny soldered joints
by heating up the
component leads suf-
ficiently.
This solder joint
results in a bad
connection.
Trim the excess
wires up to the
level of the sol-
der
•
Careless assembly will certainly lead to problems.
•
Insert the part, oriented correctly, into its correct holes in the PCB.
•
Mount the components in the correct order as stated in this manual.
•
Watch out for important remarks.
•
The component values in the circuit diagram are for reference only.
The values in this parts list are correct and must be followed.
•
Use the boxes
q
to check off your progress.
F
Before starting to build, read also the general guidelines
1. JUMPERS
q
J1
q
J2
2. DIAC
D...
q
D1: D0200YR
