8
Test & connection
ATTENTION:
A PART OF THE CIRCUIT IS ALWAYS UNDER MAIN
VOLTAGE. TAKE ALL POSSIBLE PRECAUTIONS, SO
THAT
NO-ONE CAN TOUCH ANY PART. FOR YOUR OWN
SECURITY AS FOR THE USERS' SECURITY. MOUNT
THIS KIT PREFERABLY IN AN ISOLATING HOUSING.
THE FUSE WILL MELT IN CASE OF AN OVERLOAD, RE-
PLACE IT BY EXACTLY THE SAME TYPE.
Connect the load to the screw connector marked by "LOAD" see fig. 1. Consider the max. load (5,5A)
Connect the mains voltage on the screw connector "MAINS".
See whether you have mounted the right jumper (J1 or J2).
The power voltage for the load is put on the connector. "VAC" (24 … 240VAC).
See that this voltage and the "MAINS" voltage have the same frequency and that they are either in phase
or in the opposite phase. Owing to the fact that the supply voltages of the load and the control circuit are
completely separated, one can also connect low voltage loads. This makes this circuits fits for regulations
M
110 - 240VAC
MAI
NS
LO
A
D
VA
C
L
N
L
N
Fig 1.0
N
L
N
L
L
N
M
17. Test & connection
Summary of Contents for K2636
Page 10: ...10 PCB PCB...
Page 11: ...11 Diagram Schematic diagram...
