Installation
Mounting (Using Mounting Plate)
1.Choose a mounting location on the dash board or instrument panel that will allow
room behind to run radio cables to the power source. Consider how you will use
the AUX IN, LINE OUT and USB connectors and route the appropriate extension
cables to an accessible area.
2.Once you have determined a mounting location, you will need to cut a circular
hole 3"(77mm) in diameter. At least 3.75 inch depth is needed to mount the radio.
IMPORTANT! Do not mount this unit where it can be submerged in water.
3.Slide the mounting plate over the backside of the unit and secure with the
supplied screws.
4.Press on the trim bezel to the front side of the unit.
5.Plug in all wring harnesses and cables. Refer to the wiring diagram for wire
harness connection types.
Source Unit
Mounting Screws
Trim Bezel
Panel
