EN
Installation of BASIC Motor with built-in re Remote Rontrol RF ECO
BASIC (Motor M20M400)
Please connect the remote controls correctly for a proper use of the motor with built-in
receiver.
Note: in case of a double bed;
PLEASE
install both bed parts one by one, not
together!
!
•
Manual connecting mode:
o
Plug the 220V power plug of the motor to the mains.
o
On the motor, press
2 x
the connecting button
A
until the green LED
light will light up.
o
You are in the manual connecting mode for 20 seconds.
o
Press the remote buttons
1
&
2
(first row) TOGETHER.
o
The white LED on the motor flashes 2 x and goes out. The
connection between remote and receiver was successful when the
green LED light goes out.
o
Note: sometimes the connection can take more than 10
seconds!!
o
The adjustable bed is now ready to be used.
•
Parallel operation mode
o
If you wish to use two beds at the same time with one remote control,
first connect bed 1 as described above. Connect bed 2 in the same
way but with buttons
3
and
4
(2nd row).
o
The 2nd remote control is not in use!
o
If you want to leave the parallel mode, you must connect bed 2 to the
2nd remote control with buttons 1 and 2. This way, you can operate
each bed with 1 hand control.
A.
LED +
knop/boutton/button/Taste
1.
2.
3.
4.
Summary of Contents for 8O 1600720
Page 6: ...6...
Page 7: ...Kop T te Head Kopf Voet Pied Foot Fu 85cm H J 7...
Page 8: ...G D D G Kop T te Head Kopf 8...
Page 9: ...A of ou or oder DUO 9...
