o
The adjustable bed is now ready to be used.
Synchro Mode in case of a double bed
This motors can also be connected to remote controls TOPLINE in a ‘synchro’ way;
in the
Synchro Mode
both bed parts will be adjusted at the same time by one single
remote. This by using the
optional Synchro Cable
.
•
Connect the synchro cable (X-cable - male socket) to
both
motors. This in the
7-pole socket, next to the connecting button
A
.
•
The synchro function is activated by default after connecting the Synchro
Cable.
Programming MEMORY positions
•
You can store 2 positions of the bed in the memory using the
M1
and
M2
keys.
•
Put the bed in a position you want to store.
•
Press programming key
D
until the blue LED at the top lights up brightly (after
3 sec.).
•
Now press
M1
or
M2
to store the current position.
•
The white LED on the motor flashes 2 x and will go out. The position was
stored.
PROBLEM CASE: Reset of the receiver (factory settings)
If problems occur during the installation of the motor and the remote controls you may
reset the receiver
and repeat the connecting procedure:
HOW TO RESET THE RECEIVER:
•
Press
4 x
the connecting button
A
of the motor until the white LED light goes
on, afterwards please press a
5th
time.
•
The white LED flashes 2 x and will go out. The receiver went back to the
original factory settings.
•
The connecting procedure between remote and receiver can now be executed
as described above.
**synchro
A.
LED +
knop/boutton/button/Taste
1.
D.
2.
LED
**
Only
remove the cap cover when using the synchro cable!
Summary of Contents for 4i
