HOW TO REPLACE THE REMOTE CONTROL BATTERY
9
•
The remote control uses a CR2025 lithium 3.0 V coin battery that is
commonly used in small electronic devices.
•
Push the battery compartment release button and then slide out the
battery tray on the bottom of the remote control.
•
Remove the old battery and put the new battery in, making sure that
the battery's positive side is facing up.
•
Slide the battery tray back into the remote control until it clicks.
REMOTE CONTROL
OPERATION AND STOP
1- Start the operation by pressing the setting or the auto button.
2- When you press the auto button, you can set the temperature by using the
setting buttons;
Electronic temperature control automatically regulates power consumption
based on your set temperature and eliminates annoying hot and cold cycles.
3- When you press the level button, you can set the heat steps by using the
setting buttons;
Heating capacity can be set to 4 different levels 1000W-1500W-2000W-2500W.
•
When you press the timer button, you can set the off timer between 1-9 hours by using the setting buttons;
•
When the timer is set, off timer lamp will light up and the heater will automatically shut down at the end of
the determined time.
•
To stop the off timer, set the timer as “0” or restart the heater.
•
Point the remote control towards the receiver whilst using it.
•
Remote control will not work from a distance when strong lighting
or sunlight is present. In this case, use the remote control just in front
of the control panel.
•
When you select a function with the remote control you will here
a 'beep'.
•
When the remote control is not used for a long period, please
remove the battery to avoid leakage and damage.
•
Do not allow water or liquid to get into the remote control.
How to use
It is recommended that persons who may have difficult understanding or operating the appliance controls should not be
left unattended while using the appliance. Special considerations should be given to young children and the less able
bodied!
1. Start operation by pressing the setting or the auto button.
2. Heater is turned on and operation is started with the sound of beep.
3. Press power button to stop.
HEAT AMOUNT CONTROL
OFF TIMER
Power
Timmer
Setting buttons
Automatic temperature
control
Power setting
