Do not allow the supply cord to sit or hang in front of the heater while in use and
keep it away from the body of the heater which will get hot during operation.
Keep the cable away from sharp edges during handling and installation.
Regularly inspect the power cord and plug for wear or damage and do not
operate the heater with a damaged cord, plug or loose socket or after the heater
malfunctions, has been dropped or damaged in any manner.
If the supply cord is damaged, it must be replaced by the manufacturer, it’s service
agent or similarly qualified persons in order to avoid a hazard.
Do not locate the heater immediately above or below a fixed socket outlet or
connection box. This is because the heat radiated from the appliance may damage
the electricity outlet or plug.
Always unplug the heater when not in use.
The supply cable must be at the lower end of the heater if the heater is installed at
an angle or vertically.
For installation use only the supplied accessories or original accessories approved
by the manufacturer.
Do not place articles on or against this appliance.
A minimum safety distance of 1500 mm should always be left in front of the
appliance.
This heater must be mounted at a minimum of 1800 mm above the floor.
INTRODUCTION
The AERO S carbon infrared heater is engineered as a robust indoor-outdoor heater.
Every component in the AERO S heater is optimized for performance. That includes
the veito carbon infrared tube producing mid-wave infrared heat. The AERO S
heater has weatherproof design, which means you can use it for patios, terraces,
smoking areas, conservatories, restaurants, hotels, garages, workshops, factories,
warehouses and many more.
Model
AERO
S
Voltage
220-240V AC, 50/60 Hz
Power
2500W
Dimensions (W x H x D) 820 x 180 x 55 mm
Weight
3
kg
IP Rating
IP44
4
