Veit SF26, Operating Instructions Manual

Page: 42 / 149

6.4 Commissioning
CAUTION!
Commissioning and test run
Incorrect commissioning of the SF26 shirt finisher
may result in injuries, and damage to the equip-
ment or environment.
– Commissioning, particularly the first startup of
the SF26 shirt finisher, must only be carried out
by trained personnel.
– Secure the SF26 shirt finisher against unau-
thorised startup.
– After the SF26 shirt finisher has been con-
nected to the electrical and pneumatic systems
and to the steam and condensate lines,
instructed personnel continues commissioning
and starts a test run.
6.4.1 Setup instructions for sleeve tensioning device
Setting the swivel speed (swivel out and in)
1.
Open and remove the rear cover hood.
2. Locking nuts of exhaust valves D 15_A - D 18_B.
3.
Turning the adjusting screws on the exhaust valves sets the
speed for swivelling out and in.
4.
D 15_A Swivel out sleeve tensioning
device on the left
D 16_B Swivel in sleeve tensioning
device on the left
D 17_A Swivel out sleeve tensioning
device on the right
D 18_B Swivel in sleeve tensioning
device on the right
In manual mode, the sleeve tensioning devices can be swiv-
elled in and out manually on the touch panel.
Ä
Chapter
7.3.1.6.8 „Manual mode“ on page 62
Proceed slowly and steadily on both sides during swivelling
in and out.
Once the correct setting is found (test with garment), tighten
the lock nuts of the exhaust valves again keeping the
adjusting screws in their position.
Installation
Commissioning > Setup instructions for sleeve tensioning device
18.07.2017 Shirt finisher VEIT SF26 42