9
3 Product description
VEGAPULS 42 • Three-wire with IO-Link (2 x transistor or 4 … 20 mA plus 1 x transistor)
1016153-EN-230316
frequency change is proportional to the distance and is converted into
the level.
3.3 Adjustment
The sensor must be connected to the IO-Link control via the IO-Link
master. The associated IODD (IO Device Description) is required for
operation and can be found using IODDfinder. Alternatively, a PLC
can communicate directly with the sensor using the device-specific
IO-Link parameters.
Requirement: The sensor has an integrated Bluetooth module.
•
The sensor can be operated with a smartphone/tablet (iOS or
Android operating system). The required VEGA Tools app can be
downloaded and installed free of charge in the respective store.
•
The sensor can be adjusted with a PC/notebook (Windows operat-
ing system). The necessary adjustment software PACTware (with
corresponding DTM) can be downloaded and installed free of
charge on the VEGA website.
The sensor can be adjusted via the optionally integrated display and
adjustment unit.
Note:
The housing with display and adjustment unit can be rotated 330° for
optimum readability and operability without tools.
3.4 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging consists of environment-friendly, recyclable card-
board. For special versions, PE foam or PE foil is also used. Dispose
of the packaging material via specialised recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
•
Not in the open
•
Dry and dust free
•
Not exposed to corrosive media
IO-Link
Bluetooth
Integrated display and
adjustment unit
Packaging
Transport
Transport inspection
Storage