9
3 Product description
VEGAMIP R62 • Receiving unit
41911-EN-200522
1
2
3
5
4
Fig. 2: Antenna versions
1 Threaded version, internal horn antenna with PTFE cover
2 Plastic encapsulated antenna with PP cover
3 Horn antenna (316L)
4 VEGAMIP 62 with angled antenna extension
5 Encapsulated horn antenna with PTFE cover
The emitting unit transmits a focused microwave signal via horn
antenna to the receiving unit on the opposite side. If there is medium
between emitting and receiving unit, the signal is damped. This
change is detected by the built-in electronics module and converted
into a switching command.
3.3 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging consists of environment-friendly, recyclable card-
board. For special versions, PE foam or PE foil is also used. Dispose
of the packaging material via specialised recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
•
Not in the open
Functional principle
Packaging
Transport
Transport inspection
Storage
