Wireless Microphone System
5
“A” antenna connector:
BNC connector for supplied whip antennas.
Attenuation Switch:
Switch
to select between line or mic
audio on the XLR output.
XLR Audio Output:
Balanced
line or mic level audio output.
Standard, full-sized, three-pin
XLR male connector.
Receiver Back Panel Controls and Indicators
“B” antenna connector:
BNC connector for supplied whip antennas.
Squelch Adjust:
Adjusts the squelch point (both channels, A and B). Factory set at
1.8
µ
V (minimum setting, fully CCW, recommended setting). At the
maximum setting, the receiver will squelch at about 5.5
µ
V, reducing
the receiver’s sensitivity and range. Increase the squelch (turn
clockwise) when external RF noise or interference causes undesired
squelch breaking. This problem is most likely to occur when the
transmitter is turned off or at the edge of its range.
Power Input:
Use 12 Vdc power supply (supplied).
1/4” Phone Audio Output:
Unbalanced audio output.
1/4" Phone Audio Output:
Unbalanced line level audio
Audio Level Adjust:
Adjusts the
audio level output.
