35
7 Setup
PLICSMOBILE • Mobile network unit PLICSMOBILE T81
55234-EN-191217
The following operating conditions are signalled via the blue LED
(Bluetooth status indication):
•
LED does not light:
Bluetooth switched off or power saving mode
active
•
Unsteady flashing (long OFF/short ON):
Bluetooth switched on
•
Permanent light:
Bluetooth connection is active
Information:
When the PLICSMOBILE T81 is in power saving mode, the LED
status indicators are inactive. The LED indicators are active only dur-
ing the time when a measurement with subsequent measured value
transmission takes place.
By pushing this button, a manual measured value transmission will be
triggered, independent of the configured time settings. This functions
also if PLICSMOBILE T81 is in power saving mode. Here you can
check by means of the yellow status LED if logging into the mobile
network is possible.
7.7 Internet connection and measured value
transmission
The transmission of measured values via e-mail or to VEGA Inventory
System is always based on an internet connection. For connection,
access data (user name/password) and the respective Access Point
Name (APN) are required.
When using the VEGA service package "
User fee, identification
card
" and the VEGA Inventory System, you need no access data or
additional information because the required parameters are already
preset by default. Requirement is that the VEGA service package and
the PLICSMOBILE T81 are part of the same order.
Information:
Further information and a list of current mobile network providers
along with their access data can be found in the online help of the
PLICSMOBILE DTM.
"Send" button
Internet connection
