VeEX VePAL TX300M, User Manual

Page: 72 / 421

6.7 Measurement Configuration
Tapping the
Measurements
tab opens the setup screen for the Timer, Performance Analysis, and General configurations.
Measurements tab
Go back to top Go back to TOC
6.7.1 Timer Setup
Configure a test to run for a fixed duration or a delayed start.
Mode
: Manual, Timed, and Auto selections are available
Manual:
This is linked to the Start/Stop function on the drop-down menu
Timed:
The test duration can be set by the user. The test duration can be set in seconds, minutes, hours or days. The test
is activated by the Start/Stop function on the drop-down menu
Auto:
A predetermined start time can be set by the user. The test duration can be set in seconds, minutes, hours or days.
After programming the start time and duration, press the
Start
button on the drop-down menu and the test will be
activated automatically when the programmed start time is reached.
Note:
The timed mode will be required when running a M.2100 or M.2101 performance objective.
Go back to top Go back to TOC
6.7.2 Performance Analysis
The Analysis setup page selects the ITU-T performance test that will be performed by the unit. Depending on Test mode, the
selections include None, G.821, G.826, G.828, G.829, M.2100, and M.2101.
Analysis
TX300S_e-manual_D07-00-064P_RevA00