VeEX UX400, User Manual

Page: 46 / 209

UDP/TCP (Layer 4 only):
Input Source Port and Destination Port.
BERT Setup - UDP/TCP (Layer 4)
Go back to top Go back to TOC
6.2.1.2 Traffic Settings
Traffic tab:
The user configures the traffic profile for the stream, including traffic flow, frame size, frame type, and transmit rate.
Traffic Flow:
Select from the following traffic flows:
Constant:
The selected frame is transmitted continuously according to the selected bandwidth %.
Ramp:
The selected frame is transmitted at maximum bandwidth according to the selected duty cycle and burst period.
Burst:
The selected frame is transmitted in a staircase profile according to user selectable step time, number of steps, and maximum bandwidth.
Single Burst:
Configure the number of frames to be transmitted in the burst along with the bandwidth. For example, if 100000 frames are transmitted at
12.5% of bandwidth, on a 1Gbps line, 100000 frames will transmit at a rate of 125Mbps and then the burst will stop.
Frame Size Type:
Fixed or Uniform min and max frame length values. Uniform traffic is traffic generated with a uniform distribution of frame lengths.
Frame Size (bytes):
Frame sizes can be from 64 bytes to 1518 bytes, in addition to jumbo frames up to 10000 bytes
BW (Transmit Bandwidth):
Configure the transmit rate for the test
When traffic flow is equal to Burst, two burst bandwidths are configured with burst time
When traffic flow is equal to Ramp, starting and an ending bandwidth are configured along with the bandwidth step size and duration
BERT Setup - Constant Traffic BERT Setup - Ramp Traffic
UX400 10G e-Manual D07-00-058P RevA00 Page 46 of 209