VeEX MPA, User Manual

Page: 530 / 842

Packet Tab
530
0x9200), or enter a user defined value.
Count Statistics
Table
The Count Statistics Table displays the following information
for both transmitted (TX) and received (RX) packets:
•
TX/RX - Defines which row of statistics is designated
for Transmit counts (TX) and which row is designated
for Receive counts (RX)
•
Packets - Displays the total number of packets sent
and received since the test was started
•
Pkts/sec - Displays the current rate of packets sent
and received in packets per second
•
Bytes - Displays the total number of bytes sent and
received since the test was started
•
Mbit/sec - Displays the current rate of packets sent
and received in Megabits per second
•
%BW - Displays the current percentage of bandwidth
of packets sent and received
Initial Laser Setting Controls whether the laser is on or off when the unit is turned
on.
The following options are available:
•
Off - The laser will be off when the unit is turned on.
•
On - The laser will be on when the unit is turned on.
•
Restore Previous State - When the unit is turned on,
the laser will be on or off based on its previous setting
before the unit was turned off.
Config - Strms Pg 1 and Strms Pg 2
(Specifically for LAN/WAN Ethernet testing on the Packet tab)
The Strms Pg 1 (Streams Page 1) and Strms Pg 2 (Streams Page 2) screens are used
for configuring and testing packet streams.
MPA_e_manual_D07-00-129P_RevA00