VeEX MPA, User Manual

Page: 21 / 842

Getting Started
21
•
When the system is shipped from the factory, the AM4022
processor’s default IP
Address is set to 192.168.0.10 , with a Subnet Address of 255.255.255.0
•
The MCH
controller module’s default IP Address is set to
192.168.0.11 , with a
Subnet Address of 255.255.255.0
o
The MCH’s IP Address is only required if an External BITS/SETS chassis
clock is plugged into the RJ-48 Clock In/Out port
o
See Cha
nging the MCH module’s IP Address
for changing the MCH
module’s IP Address
The following methods can be used for changing the
AM4022’s IP Address:
•
USB flash drive ( preferred method )
•
Remote GUI Client ( must currently be connected by the Remote GUI client or
VNC )
Note: Regardless which card type or method you use to change the MPA's IP Address,
you will need to reboot the MPA in order for the setting to take effect.
For assistance with changing the IP Address, contact Customer Tech Support .
Changing the IP Address with a USB Flash Drive
The ability to change the MPA's IP Address with a USB flash drive (e.g., pen drive) is a
very simple and easy method of changing the IP Address, especially if you do not know
the MPA's current IP Address.
MPA_e_manual_D07-00-129P_RevA00