VeEX MPA, User Manual

Page: 19 / 842

Getting Started
19
foam padding must be 3" to 4" inches in thickness (70 to 100 mm) and
applied to all six (6) sides of the unit to provide adequate protection.
4. Make sure that the unit cannot move or shift within the container.
5. Securely seal the shipping container and mark FRAGILE on the container
to ensure careful handling.
6. Include the RMA number on the outside of the shipping container.
7. Contact Customer Technical Support
for the repair department’s return
shipping address.
Shipping Charges
The customer is responsible for paying all shipping charges (including insurance, duties,
taxes, customs fees, and/or other charges) for RMA units being shipped to VeEX, from
any location within or outside of the United States.
When the service is complete, your unit will be returned to the customer postage paid
(excluding Calibration RMA's), if the shipment is within the United States. Customers
outside the United States are responsible for all shipping charges.
Configuring the IP Address
Configuring the IP Address Overview
SCM-210 Controller Card
This section describes how to configure the IP Address programmed on MPA systems,
containing the
SCM-210 (System Controller Module) card.
For MPA system containing an AM4022 processor and MCH controller card, please
refer to the section below for configuring the IP Address.
The MPA’s IP Address is configured on the
SCM-210 controller card and is used for all
Ethernet communication to the MPA system, such as Remote GUI , VNC and SCPI , via
the RJ-45 LAN Port .
The MPA’s current IP Address is displayed on the OLED display screen.
MPA_e_manual_D07-00-129P_RevA00