13.0 Setup - Main Menu
The Main menu contains CX380C related system operation and parameter settings. Select the
Setup
option
in the left
panel to access the
Setup
screen.
Channel Table
Default Location
For more information on setting up
Channel Tables, Locations, and Test Point Compensation, see
.
Tilt A&D Start Mode
- Select the Tilt 'A&D Combined' mode to start in Graph or Table mode.
Unit
- Changes the display unit between dBmV and dBuV.
TP Compensation
- Turns the Test Point (TP) compensation On or Off. Create or edit the name of test point locations and
the associated compensation value is added to the level measurement results.
VeCheck Scan Range
- Select the maximum of the frequency range for the advanced system scan.
VeCheck Scan Type
- Select the channels to scan or use the pre-configured channel table.
Analog C/N Offset
- Sets the offset frequency for the noise measurement, 1.00 MHz to +2.50 MHz.
Hum Zone
- Sets the Hum/low frequency of a known disturbance or connection causing distortion.
D3.1 OFDM Table
- Create and edit OFDM channel table.
The OFDM Table feature is applicable only for Japan.
TDR Cable Type
- Select type of cable to assess.
Table Lock
- Locks the channel table to prevent accidentally erasing of pre-stored channel tables.
Sweep table (RP)
- Create or edit return path sweep tables.
This feature is currently not supported.
CaLan Master Profile
- Select the CaLan 3010H+ profile to use.
Upstream Bound
- Set the Upstream Path frequency.
Setup - Main Menu
CX380C User Manual RevA00
Page 103 of 105
