1
Introduction
This manual describes the site preparation and console installation procedures for all TLS-50 Monitoring Systems.
Except where noted, the procedures described herein apply to all consoles. TLS-50 is used throughout Table 1
lists the various TLS-50 consoles and options by form number. Figure 1 shows where on the top of the console
you can find the information about your console’s form number.
Figure 1. Locating the console form number
This manual assumes that you installing the monitoring system in a new site (before pavement is put down and
with no wiring runs in place). Some of the topics covered in this manual are listed below.
•
Laying out the site
•
Mounting the console and connecting power wiring
•
Assembling and installing probes
•
Installing wiring conduit between the console and probes
•
Field wiring probes
•
Connecting probes to the console
•
RS-232 serial communication connection requirements and available serial commands (consoles with com
option)
•
Troubleshooting information
Table 1.- TLS-50 Consoles and Features
Console Form No.
Console Type
8469X0-060
TLS-50 w/keypad and display, up to 6 probes
8469X0-160
TLS-50 w/keypad and display, w/relay, up to 6 probes
8469X0-260
TLS-50 w/keypad and display, w/com and relay, up to 6 probes
8469X0-230
TLS-50C w/o keypad or display, w/com, up to 3 probes
8469X0-460
TLS-50 w/o keypad or display, w/com and relay, up to 6 probes
FORM NO.: 846960-XX0
SERIAL NO.: XXXXXXXXXXXXXX
MANUFACTURED BY:
VEEDER-ROOT, 125 POWDER FOREST DR.
SIMSBURY, CT. 06070 U.S.A.
Console Form No.
consoles\formlabel.eps
Label on top of console
