Installation Guide
Contractor Certification Requirements
1
Introduction
This manual describes site preparation and installation procedures for the Veeder-Root TLS RF Wireless
System. This system is designed for standard tank monitoring and leak detection* applications in which in-
ground probe wiring is either impractical or non-existent.
Procedures contained within this manual include:
•
Mounting the TLS RF Wireless Interface Unit (TLS RF) and connecting power wiring.
•
Installing TLS RF Wireless System’s receiver, transmitter, and repeater components throughout the
site.
•
Connecting the TLS RF to the TLS console.
Other required devices, such as the TLS console and necessary magnetostrictive (mag) probes/mag sump
sensors, are to be installed following instructions shipped with those devices.
After installing the TLS RF Wireless System, you must configure the probes and sensors in the TLS console
following instructions contained in the console’s System Setup Manual.
*Certified SLD (Static) & CSLD (Continuous) Leak Detection for single tanks and Mag Sump Sensor monitoring, where ambient
interference is not a factor.
Component Compatibility
The Veeder-Root Form Number/Part Number TLS RF Wireless System compatible components are as
follows:
•
8466 TLS-IB console
•
8469 TLS-50 console
•
8470 TLS-350 console
•
8482 TLS-350R console
•
8485 TLS-300 console
•
8560 TLS2 console
332235-011 Transmitter with 332425-011 Battery Pack will monitor probe/sensor form numbers listed
below:
•
8462, 8463 and 8563 Mag Plus Probe
•
8468
Global Mag Probe
•
8570
Mag Sump Sensor
