Installing The TLS-450PLUS Console
Connecting The Power Wires To The Console
8
Figure 4. TLS-450PLUS Console - Fixed Comm Modules
Connecting The Power Wires To The Console
This section concludes the TLS-450PLUS retrofit installation by connecting power to the console.
1. With the left of the console open, remove the two screws that attach the power connector cover plate (see
2. With the cover removed, notice the power connector already attached to the console. This is where the wires
connect.
3. Next, remove the knockouts for console power and install the conduit from the power trough to the console. If
local codes require rigid conduit, plan carefully before knocking out these holes. The console is prepunched for
½” conduit. This should be large enough since the only wires going through this conduit will be for L1, neutral,
panel ground and earth ground, and possibly 1 relay. Refer to manual 577014-073 for proper wire gauge.
Table 1. Selectable Comm Module Permissible Slots and Port Availability
Comm Module
Comm
Type
Slot 1
Slot 2
Slot 3
Port Port
Port
1
2
1
2
1
2
R
S
-2
3
2
S
i
n
gle Port (al
s
o EDIM,
S
atellite
S
-
S
AT a
nd
S
atellite H-JBo
x
a
pps
.)
S
erial
NC
C
NC
C
NC
C
R
S
-2
3
2 D
u
al Port (al
s
o EDIM,
S
atellite
S
-
S
AT a
nd
S
atellite H-JBo
x
a
pps
.)
C
C
C
C
NC
C
R
S
-48
5
S
i
n
gle Port
NC
C
NC
C
NC
C
R
S
-48
5
D
u
al Port
C
C
C
C
NC
C
R
S
-2
3
2/R
S
-48
5
D
u
al Port
C
(R
S
-2
3
2)
C
(R
S
-48
5
)
C
(R
S
-2
3
2)
C
(R
S
-48
5
)
NC
C
(R
S
-48
5
)
S
iteFa
x
/ Mo
d
e
m
NC
C
NC
C
NC
C
CDIM
DIM
C
NC
C
NC
----
----
USB ports: (1) upper, (2) lower
Future expansion port
Ethernet ports:
(1) upper
Ethernet port 2:
middle and lower switched
Comm
S
lot
s
Front of
Console
1
2
3
4
5
