4. Operation with the scale in weighing mode:
4.1. Turn on and Turn off
– Turning on and turning off is done by the ON/Off switch, which
is on the right at the bottom of the case. First the indication test starts, and then for short the display
shows the model and the software version. Then the scale is ready to work and the display:
4.2. Turn on and Turn off of the backlight
- Turning on and turning off of the backlight is
done by Back Light On/Off switch, which is on the left at the bottom side of the case.
4.3. Zero setting
– If there is some minimal reading on the display, it can be zeroed by
pressing
key.
4.4. Work with tare
- After placing the package (tare) on the pan, press
key. Readings
on the display is zeroed and the indicator „net weight“ lights up. This mean that next readings will be
net weight. To remove tare, unload the scale. The display will show the weight of the tare with „-“ and
the indicator „tare“ lights up. By pressing TARE key the scale is zeroed again.
4.5. Weight measuring
– The item to be weighted is placed on the scale pan; the first line of
the display shows the measured weight. The weight data are considered correct, when the indicator for
stable reading lights up.
5. Work with the menus and service mode functions of the scale
To enter the main menu of the scale, press
.key. To enter a submenu and confirm the select
adjustement/parameter, press
key. Moving between the different submenu and parameters is
with
and
keys.
- Entering the submenu Bat, the display shows voltage of the built-in rechargeable battery in
Volts.
- Entering the submenu Fine, the display shows the measured weight in high resolution.
In this mode all data transmission over the serial interfaces is forbidden.
- In this submenu, a protocol for connection with the first serial interface is selected.
The sustained protocols are:
OFF – the port if turned off;
Pr1 – Protocol VEDIA with uninterrupted weight transmission;
Pr2 – Protocol VEDIA with a single time weight transmission after external command and
pressing key Enter;
Pr3 – Protocol for “Datecs” cash-registers;
Pr4 – Protocol for connection with cash-registers produced by “Zavod Electronica”, “ZEKA”,
“Orgtechnika”;
Pr5 – Protocol for “ZIT”cash-registers.
After each change of the protocol, the scale is restarted.
- In this submenu, a protocol for connection with second serial interface is selected. The
sustained protocols are:
6
