Vedeneyev M-14P, Maintenance Manual

Page: 375 / 381

TO M-14P MS
TASK CARD No. 204
MS ITEM
PROCEDURE
-. Adjustment of Governor on Engine
OPERATIONS AND TECHNICAL REQUIREMENTS CORRECTIVE
ACTIONS
CHECKED
BY
1. Set the governor control lever in the pilot's cabin to the extreme position corresponding
to the airscrew maximum pitch.
2. Turn the governor control shaft all the way clockwise (the spring is fully released).
3. Pit the roller on the control shaft hex so that the hole intended to attach the cable is at
the point of cable contact on the roller.
4. Secure the roller in this position on the shaft. 5. Adjust the cable length and secure it on
the governor roller.
6, Check operation of the governor control system and make sure the governor control
shaft turns through a complete angle of about 160° without playa, jamming or dead sectors.
TR . Plays, jamming or dead sectors are not allowed.
7. Start and warm up the engine (Ref. 072.00.00, Task Cards Nos 201. 202).
8. Check operation of the governor and its control linkage by changing over the airscrew
from. low to high pitch and check operation of the airscrew and governor at equilibrium speed of
rotation (Ref. 072,00.00, Task Card No. 202).
Eliminate playa and
jamming by adjusting rods,
cables