Vedeneyev M-14P, Maintenance Manual

Page: 268 / 381

TO M-14P MS
T A S K C A R D No. 202
MS ITEM PROCEDURE
'.
DC
preservation of Hew Carburetor
OPERATIONS AND TECHNICAL REQUIREMENTS CORRECTIVE ACTIONS CH
ECKED BY
1, Unpack the new carburetor.
2, Remove preserving grease from the external surfaces with a brush moistened in clean
gasoline.
3. Blow the external surfaces with dry compressed air. 4. Drive out upper drain plug (2)
(Ref. Fig. 201).
5. Drive out plug (3) (Ref. Fig. 202) for measuring the initial position of the altitude control
needle.
6. Remove shipping cap from fuel inlet connection (6) (Ref. Pig. 201). 7. Connect the
hand pump line to connection (6). 8. Set the throttle lever to the full open stop.
9. Drive out plug (6) (Ref, Fig, 202) for measuring air pressure in the regulator air space.
p 10, Supply air at a pressure of up to 0.5 kgf/cm in-to the hole for plug (6).
p 11. Flush clean gasoline at a pressure of (0.5^0-2) kgf/cm through fuel inlet
connection (6) (Ref. Fig. 201) till gasoline appears from the hole for upper drain plug (2).
12. After gasoline appears from the hole, reinstall plug (2).