VEC-121K Owner's Manual
Crystal Radio Set Kit
15
For the remaining steps, align the Fashnstock clips as shown in the drawing.
!
Mount a second clip at the
ANT
position on the breadboard using a Phillips
screw.
!
Mount a clip using a Phillips screw at the
DET1
position on the breadboard.
!
Mount a clip using a Phillips screw at the
DET2
position on the breadboard.
!
Mount a clip using a Phillips screw at the
EAR2
position on the breadboard.
!
Mount a clip using a Phillips screw at the
EAR1
position on the breadboard.
The six Fahnstock clips should all be mounted at this point.
!
Find the coil and the remaining two Phillips head screws.
!
Mount the coil to the board using the two Phillips head mounting screws.
Before tightening the screws, make sure the two 16” coil lead wires are
oriented towards the front of the breadboard. You may now tighten the
screws so the coil is mounted snugly against the board.
NOTE: Over-
tightening the screws may damage the coil form, or cause the screws to
strip the pine board.
Your crystal receiver should resemble the following drawing:
You have finished Phase 3 of your crystal set receiver project. In Phase 4, we'll
be doing the wiring between the crystal set’s components.
Phase 4: Wiring the crystal set
In phase 4, most of the wiring will involve using the two 16” coil wires. For
clarity, we are only showing the components we are going to be working with.
Summary of Contents for VEC-121K
Page 31: ......
