9
Replacement Parts
For replacement parts (bulbs, Ni-MH batteries, fuses, etc.), contact Vector Customer
Service, toll-free, at (866) 584-5504.
Battery Replacement
It is recommended that the unit be returned to manufacturer for battery replacement.
Contact Vector Customer Service, toll-free, at (866) 584-5504.
WARNING
• Do not dispose of the battery in fire. This may result in an explosion.
• Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting, which can result in
injury or fire.
• Do not expose the battery to fire or intense heat as it may explode.
Battery Disposal
This unit contains a Ni-MH battery. Dispose of used batteries properly. For more
information on recycling batteries, call toll free (800) 822-8837.
Fuse Replacement
1. Using a screwdriver, open the fuse cover and remove the defective fuse.
2. Insert a replacement 2 amp fuse into the FUSE socket.
3. Close the fuse cover.
CAUTION
THIS UNIT USES A 2 AMP FUSE. FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE, REPLACE THE FUSE ONLY WITH ONE OF THE
SAME TYPE AND RATING.
8
OPERATING THE LANTERN
The lantern can be tilted up and down to direct the beam where
you need it. It is controlled by the ON/OFF trigger switch located
beneath the unit handle.
Make sure the light is turned OFF when the unit is being recharged
or stored.
Note:
Do not operate the lantern and TV at the same time when using the 120 volt
AC adapter.
OPERATING THE LED AREA LIGHTS
The LED Area Lights are controlled by the ON/OFF switch on top
of the lantern. Slide the switch to the ON position to turn the LEDs
on. Slide the switch to the OFF position to turn the LEDs off.
CARE AND MAINTENANCE
Recharging Back-up Power
120 Volt AC Charging
You can watch TV or listen to the radio while charging the back-up power battery.
1. Plug the AC plug of the AC/DC adapter/charger into any
standard 120 volt AC wall outlet.
2. Plug the barrel connector attached to the AC/DC
adapter/charger into the small barrel receptacle labeled “DC
12V IN”.
3. Charge the back-up power battery regularly so it is ready for
emergency use.
Note:
The unit cannot be overcharged using the AC method.
Using the Hand Crank
For ease of use, the crank handle can be “locked” into place. Flip
the handle to release and press it against the unit body to secure
into position. Rotate the dynamo crank handle to generate power
if back-up battery power is low and to recharge the back-up
rechargeable batteries.
Note:
The back-up power operates the LED area lights and the radio only. The TV and
lantern will not operate from the back-up power, they operate only from the
replaceable “C” size batteries, AC adapter or 12 volt DC power adapter.
VEC135_Manual_051705 5/18/05 2:57 PM Page 8
