background image

7

POSITIVE GROUND SYSTEMS:

NOTE

: In the rare event that the vehicle to be started has a Positive Grounded System (positive

battery terminal is connected to chassis): Replace step 4 and 5 above with steps, 4a and

4b and then proceed to steps 6 through 8 below.

4a.  Connect negative (-) black clamp to vehicle battery ‘s negative terminal.

5a.  Connect positive (+) red clamp to vehicle chassis or a solid, non-moving,

metal vehicle component or body part. DO NOT clamp directly to positive

battery terminal or moving part.

6. Turn jumpstart system ‘s power switch to ON position.

7. Start vehicle (do not turn key for longer than 5-6 seconds).

8. After vehicle starts, turn jumpstart system ‘s Safety Switch to OFF position. Remove clamps

(disconnect the negative (Black) jumper cable first; followed by the positive (Red) jumper

cable) and replace them in the built-in storage holsters. Squeeze the handles and slide the

clamp into position and release your grip.

CAUTIONS:

1.If engine fails to start, leave ignition key turned off, make sure safety switch is off and

disconnect the negative (-) clamp first, then the positive (+) clamp. Try again later - the engine

may be flooded.

2. Recharge jumpstart system after each use.

WARNINGS:

• Always disconnect the engine jumper clamp first; followed by the battery jumper clamps

• Never allow red and black clamps to touch each other or another common metal conductor

– this could cause damage to the unit and/or create sparking/explosion hazard

• There is a risk of explosive gases being released when batteries are improperly charged or

discharged, failure to follow instructions may cause property damage, explosive hazard,

and/or personal injury

• Always use protective eyewear when using this product: contact with battery  acid may cause

blindness and/or severe burns

• Keep out of reach of children

• ALWAYS store battery clamps in built-in holsters when not in use and never touch battery

clamps together-this can cause dangerous sparks, power arcing and/or explosion

FIRST AID:

• Skin: If battery acid comes in contact with skin, rinse immediately with water, then wash

thoroughly with soap and water–If redness, pain, or irritation occurs, seek immediate

medical attention.

• Eyes: If battery acid comes in contact with eyes, flush eyes immediately for minimum of 15

minutes - SEEK IMMEDIATE MEDICAL ATTENTION.

3.

CHARGING/RECHARGING

For maximum battery life, we recommend that the START-IT COMPACT PRO™ system be kept

fully charged at all times. If the battery is allowed to remain in a discharged state, battery life

will be shortened. NOTE: Recharging battery after each use will prolong battery life; frequent

discharges between recharges will reduce battery life.

Summary of Contents for Start-It Compact Pro VEC020C













Reviews: