Vector G08 Series, Faq

Page: 27 / 42

G08 Vector Monitor Guide
Page 27 of 41
CAP KIT SUMMARY:
There are some known problems with Zanen and Bob Roberts cap kits. Below is a recommended
list of parts. Almost all of the suggested replacement capacitors are upgraded in terms of voltage
rating and should make your G08 monitor last longer and run cooler. If you would like to make a
cap kit of your own, here are the suggested parts that you will need:
G08-003 Cap Kit Parts List
PCB Location Part Description Upgrade Notes
Deflection C401 1000uf 160V Radial Capacitor Yes Original was 80V
Deflection C405 10uf 50V Radial Capacitor Yes Original was 25V
Deflection C406 10uf 50V Radial Capacitor Yes Original was 25V
Deflection C411 22uf 350V Radial Capacitor Yes Original was 250V
Deflection C601 47uf 35V Radial Capacitor Yes Original was 16V
Deflection C701 47uf 35V Radial Capacitor Yes Original was 16V
Input C800 10uf 50V Radial Capacitor Yes Original was 16V
Input C801 10uf 50V Radial Capacitor Yes Original was 16V
Input C802 10uf 50V Radial Capacitor Yes Original was 16V
Input C803 10uf 50V Radial Capacitor Yes Original was 16V
HV C900 4.7uf 35V Radial Capacitor Yes Original was 16V
HV C901 4.7uf 35V Radial Capacitor Yes Original was 16V
HV C904 22uf 35V Radial Capacitor Yes Original was 16V
HV C905 22uf 35V Radial Capacitor Yes Original was 16V
HV C911 100uf 35V Radial Capacitor
HV C916 47uf 200V Radial Capacitor Yes Original was 160V
Note: some of the capacitor locations will differ slightly from the descriptions above, depending on
the deflection board revision you have. Generally speaking, you will be replacing all electrolytic
capacitors on the deflection and HV boards. If the list above states C405, it could be C407 on your
board. Make notes on what capacitors you remove, and replace those locations.
Capacitors C601 and C701 on the deflection board appear only on the schematics and are not listed
on the parts list of any manual. C601 and C701 are connected to pins 12 and 6 of IC600
respectively.