6
CONNECTING TO A PORTABLE 12 VOLT DC POWER SUPPLY,
FOR USE AWAY FROM VEHICLE
- Make sure that the unit’s COOL/WARM/OFF switch is in the OFF position.
- Insert the 12 volt DC socket on the portable power supply.
- Continue with steps 4-9, for cooler or warmer function. Observe all CAUTIONS
AND WARNINGS.
Note:
With a current draw of approximately 4-amps (48-watts), the unit will operate
for approximately 50 minutes from a fully charged 12 volt DC portable power
supply such as the Vector Pocket Power™ or Pocket Generator™. A standard 17
Ampere Hour Jump-starter/Power Supply such as the VEC021 series - can
operate the cooler/warmer for approximately 6 hours.
CONNECTING TO AN AC (120V)/DC (12V) POWER ADAPTER
• Plug converter’s (VEC004A - 120V) power cord into standard 120 Volt 60 HZ outlet
• Make sure that unit’s COOL/WARM/OFF switch is in the off position
• Insert the 12 Volt DC socket of the AC/DC power adapter
• Continue with steps 4–9 for cooler or warmer function
OBSERVE ALL CAUTIONS AND WARNINGS.
FUSE REPLACEMENT
The power cord is fuse-protected against short-circuiting, by a 5-amp fuse
located in the tip of the 12 Volt DC plug. If the DC socket is powered, but the unit
does not operate, then the cooler/warmer fuse may be open.
To inspect or replace the DC Power Cord Fuse
1. Unscrew the end-cap of the cigarette lighter plug.
2. Remove fuse, inspect it for an open element, and replace with a new 10-amp
fuse, if needed.
3. Re-attach the end-cap to the plug.
4. If new fuse opens, call Vector® Customer Service department for further
instructions and possible return/replacement. This unit is not user-serviceable,
it must be returned to Vector® Manufacturing for professional service or
repair. Any attempt to service by user will void warranty.
CARE AND MAINTENANCE
The
Vector
®
Deluxe Console Thermoelectric Travel Cooler & Warmer
is ruggedly
constructed to provide years of dependable service.
- After each use, clean the unit, inside and out, with a soft cloth and mild
soap solution.
- Do not scrape, scratch or puncture the surface of the cooler with sharp objects
or abrasives.
- Dry the unit properly and store in a cool, dry place.
- Always make sure the power cord is disconnected before storing.
- Never allow the cooler/warmer to be immersed in liquid.
