OPERATING THE UNIT IN CORDED MODE
Insert the Adapter’s DC Connector of the AC/DC
Charging/Power Adapter into the 12 Volt DC
Charging Port. Insert the plug end into a
(powered) standard North American 120 Volt
60Hz outlet. Operate the unit as outlined in the
previous section.
RECHARGING THE BUILT-IN BATTERY
Insert the Adapter’s DC Connector of the AC/DC
Charging/Power Adapter into the 12 Volt DC
Charging Port. Insert the plug end into a (powered) standard
North American 120 Volt 60Hz outlet.
Do not charge for
longer than 8 hours.
Note:
The red Charging Indicator LED will light to indicate
the unit is charging.
Battery Disposal
This unit contains an Ni-MH battery and should
be disposed of properly. For more information on
recycling batteries, call toll-free (800) 822-8837.
WARNINGS
• Do not dispose of the battery in fire. This may result
in an explosion.
• Before disposing of the battery, protect exposed
terminals with heavy-duty electrical tape to
prevent shorting, which can result in injury or fire.
• Do not expose the battery to fire or intense heat as
it may explode.
INTRODUCTION
Thank you for purchasing the
VEC143 26 LED Bright Bar
®
.
Please read this manual carefully before use to ensure optimum
performance and avoid damage to the unit.
FEATURES
• 26 high-intensity LED bright bar illuminates a wide area
• Corded or cordless operation
• Built-in rechargeable NiMH battery (with supplied 120 volt AC
Charging/Power Adapter)
• Hi/Low settings extend runtime
• High impact, weather- & shatter-resistant ABS housing
• 360° Swivel Hanging Hook for hands-free use
• Seven hours continuous runtime on LOW setting, four hours
continuous runtime on HIGH setting, on a single charge
• Rubber Base allows unit to sit on flat surfaces
OPERATING THE UNIT
Position the unit as desired. Press the HIGH/OFF/LOW Switch
on the side of the unit.
The up position turns the unit ON in HIGH setting.
The down position turns the unit ON in LOW setting.
The center position turns the unit OFF.
IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY
TO PERSONS:
• Do not look directly at the lighted lamp.
• Charge or power this unit only with originally supplied
Class 2 Transformer. Consult manufacturer for replacement.
• DO NOT charge this unit or use it in corded mode in
conditions where it may come in contact with oil or liquids.
CAUTIONS
• DO NOT submerge this unit in liquids of any kind.
• Do not charge or use this unit in corded mode in the rain, snow or
other wet conditions.
• Make sure the adapter cord is placed so it is not tripped over or
damaged by pinching, abrading or cutting. Do not place it near
moving objects, doors or sharp objects. Discontinue use if the
adapter or cord is damaged.
• Do not expose the adapter cord to extreme heat.
• This is not a toy — keep away from children.
• Do not operate unit if there is any evidence of damage. To replace
worn or defective parts, contact Customer Service Department, toll-
free, at (866) 584-5504.
PLEASE READ THIS MANUAL BEFORE USING THIS UNIT.
SAVE THESE INSTRUCTIONS
VEC143_Manual_021606 2/27/06 5:02 PM Page 4
