Page 3
Installation
IT Is IMpORTAnT THEsE
InsTRUCTIOns ARE READ
FULLY BEFORE
InsTALLATIOn
•
This product should not be
used for any purpose other
than that for which it was de-
signed and as shown in this
leaflet
•
All packaging should be re-
moved and the unit checked
for damage in transit. If
there is any damage, please
contact your supplier
•
The Mini DC will normally be
fitted into a loft or ceiling void.
•
In order to comply with Construction (Design & Management) Regulations, sufficient access for safe
maintenance (recommended on an annual basis), or removal following installation, MUsT be
provided for this product. We recommend that a clearance of at least 150mm is available on each
side of the cabinet to allow access to the motors. see dimensions diagram.
•
Regulations and current Building Regulations. In order to comply with these, it may be necessary to fit fire
dampers or other similar devices.
•
Flue gases from fuel-burning equipment must not be drawn into a living area. If any room from which
air is extracted contains a fuel burning appliance, such as a central heating boiler, then its flue must
be of the sealed or balanced flue type, or allowance must be made for an adequate supply of air into
the room.
•
The unit must
nOT
be installed:
-
where there is excessive oil or grease
-
where there are hazardous gasses, liquids or vapours that are flammable or corrosive
-
in ambient temperatures above 50ºC or lower than 5ºC
-
in humidity levels above 90% or in a wet environment
•
Where possible the unit should
nO
T be installed directly above a bedroom or living room.
•
The condensation drain
MUsT
be fitted
•
Care should be taken to ensure that ducting is free from blockages
•
External grilles should be located a minimum of 600mm from any flue outlet in accordance with all
Regulations
•
The unit must be connected to a 230-240v, 50Hz single phase electrical supply.
• A triple pole isolation switch with contact separation of at least 3mm must be used to connect the
appliance to the fixed wiring when using the Switched Live.
•
The product should only be connected to the mains electricity supply or electrical outlet if:
- your electrical voltage and frequency correspond to those shown on the rating label.
- the capacity of your electricity supply is sufficiently powerful to operate the product at its maximum
power.
•
If one of the spigots is not connected to ducting a safety grille
MUsT
be fitted to that spigot, so that it is
impossible for any moving part to be touched.
Installation of the appliance
MUsT
be carried out by a qualified and suitably competent person and should be
carried out in clean, dry conditions where dust and humidity are at minimal levels. The unit is not suitable for
installation to the exterior of the dwelling.
Transportation, packaging and storage prior to installation
• Care should be taken when transporting the unit Dropping or knocking will damage the inner workings
of the unit.
• The unit should always be stored in a clean, dry environment.
• Remove all packaging before installation.
pre-inspection
• Inspect the unit and electrical supply cord for any damage (damage must be repaired by a suitably
qualified and competent person.)
