5
6
11
INSTALLATION
1.
check there is nothing missing in box
2.
remove front cover
3.
drill hole in wall -
allow extra width if using
ducting - it is the installer's responsibility to
use the appropriate core cutter to obtain
the correct hole diameter.
4.
use fan assembly as template to mark
drill holes
5.
drill 4 x 6mm dia holes
6.
fit wall plugs
7/8 decide whether to have cable access
from rear (recessed) or top (surface) of fan -
if from top ensure that included grommet is
properly fixed. (See dia 8). If cable is to come
through rear of fan, fit rubber ring (included)
9. screw fan to wall
10. connect cable using cable clamp - see dia 10.
NB this fan is double insulated and does not
need to be earthed
11. replace front cover
IMPORTANT
If the fan is installed in a ceiling with a vertical duct
passing through an unheated space, a condensa-
tion trap
MUST
be fitted. Any ducting in an unheat-
ed space should also be insulated according to the
latest Building Regulations recommendations in
the Domestic Ventilation Compliance Guide.
Failure to do this could result in condensation
affecting the operation of the fan and cause dam-
age to the ceiling.
Summary of Contents for ELEGANCE EL1003DT
Page 5: ...5 6 7 9 8 10...
