70
©Vecow ECX-1000 User Manual
GETTING TO KNOW YOUR ECX-1000
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block in the back panel. Please find below the general wiring
configuration.
For testing purpose, you can refer to the picture below to simulate ignition signal
input controlled by a latching switch.
Note :
1.
DC power source and IGN share the same ground.
2.
ECX-1000 supports 6V to 36V wide range DC power input in ATX/AT mode. In
Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
3.
For proper ignition control, the power button setting should be in "Power
Down" mode.
In Windows, for
example, you need
to set "When I press
the power button" to
"Shut down."
Pin No.
Definition
1
Ignition (IGN)
2
SW+
3
SW-
IGN
V+
Summary of Contents for ECX-1000 series
Page 95: ...87 Vecow ECX 1000 User Manual SYSTEM SETUP Step 11 Finished...
Page 97: ...89 Vecow ECX 1000 User Manual SYSTEM SETUP Step 3 Install DDR4 RAM module into SO DIMM socket...
Page 99: ...91 Vecow ECX 1000 User Manual SYSTEM SETUP Step 3 Install Mini PCIe card into socket...
Page 101: ...93 Vecow ECX 1000 User Manual SYSTEM SETUP Step 4 Fasten washer 1 and 2 Step 5 Finished...