47
GETTING TO KNOW YOUR ECS-9700/ 9600 GTX1050
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block located in the back panel. Please find below the
general wiring configuration.
For testing purpose, you can refer to the picture above to simulate ignition
signal input controlled by a latching switch.
Note:
1. DC power source and IGN share the same ground.
2. ECS-9700/9600 GTX1050 supports 10V to 36V wide range DC power input
in ATX/AT mode. In Ignition mode, the input voltage is fixed to 12V/24V for
car battery scenario.
3. For proper ignition control, the power button setting should be “Power down”
mode.
In Windows, for
example, you need
to set “When I press
the power button” to
“Shut down.”
Pin No.
Definition
1
Ignition (IGN)
2
External Power S/W +
3
External Power S/W +
IGN
V+
