DLKPro Inspection Key • Operating Instructions – Edition 03/2012
5 Downloading data
Downloading mass memory and driver cards
Insert your company card, control card or workshop
card into the digital tachograph.
Open the cover of the digital tachograph's
download interface.
Remove the cover from the DLKPro’s download
plug.
Insert the DLKPro’s download plug into the
download interface of the digital tachograph.
When the DLKPro is connected, its LED flashes
green.
A progress bar shows how the download is
progressing.
When the download has finished, the LED on the
DLKPro remains green and beeps indicate that the
download was successful; see note on page 13.
When the data has been transferred, remove the
DLKPro from the download interface.
Replace the cover, close the download interface of
the digital tachograph and remove your company
card, control card or workshop card from the digital
tachograph.
You can then view and evaluate the downloaded data
either on the screen or using the “DownloadTools”
PC programme; see pages 16 and 28.
Note
: If a driver card is inserted in the digital
tachograph, its contents – together with the
tachograph’s mass memory – are downloaded
automatically.
Note
: If the download was not successful, the LED on
the DLKPro flashes red and intermittent beeps can be
heard.
• In this case, check whether or not the DLKPro has
enough memory available; see page 17.
• Try the download again.
If the download fails a second time, use the
PC programme to collect the support files and
contact your service partner; see page 38.
