GB
C
08
9
11. Entering your wheelsize
Your VDO CYTEC identifies wheelsize as WS = wheelsize.
following default is entered
wheelsize = WS = 2155 mm
Watch out:
Above default is automatically applied after a battery change.
After a battery change, the correct wheelsize for your bike has to be re-entered
How is the wheelsize precisely determined?
Place the front wheel of your bike with the valve at the bottom, mark this position with a line and push your bike ahead until exactly
one rotation of the front wheel is completed. Draw another line where the valve now is. Take a ruler and measure the distance between
marks 1 and 2 which reflects the wheelsize = wheel-circumference. The figure measured (inches or mm) is the wheelsize to be entered
into your computer
10. Set-up mode
Your VDO CYTEC C 08 features the following set-up procedures
wheelsize = WS
set-up starts out of TRP in display
clock = CLK
set-up starts out of CLK in display
odometers = ODO
set-up starts out of ODO in display
No matter which set-up mode is used for your VDO CYTEC , the procedure is the same.
You can start the set-up mode for a certain display by pressing the MODE 1 button for 5 sec. With this MODE button you may also
exit the set-up mode at any time.
Once the set-up mode is activated, MODE 1 and MODE 2 buttons are covered with following instructions:
MODE1
changing from one enter display to the next enter display
MODE2
selection of figure to be entered, changing from KMH to MPH mode
