4
V
CALL MONITORED WIRELESS VEHICLE INTRUSION SYSTEM
Model VC 1000
INSTRUCTIONS
V
CALL KEYPAD Model VC 100
OPERATION
The KEYPAD can monitor up to 4 vehicle (cars). Each zone has an LED, a push button, and an output
relay. Each zone will monitor one vehicle.
1
The KEYPAD can be turned on and off by pressing the power button (light bulb icon). When
powering up the KEYPAD all LEDs are illuminated. The green “power” and amber “car”
LEDs lights momentarily. The red zone LEDs light for 3 seconds indicating zones
programmed to a vehicle. Zones available for programming are not lit.
2
When an alarm signal is received the appropriate red zone LED will illuminate, the piezo will
sound and the output relay will be activated. This is an alarm condition.
3
The alarm condition can be reset by pressing the appropriate zone push button. If the alarm
condition is not reset the alarm condition will automatically reset after 5 minutes. The red
zone LED will repeatedly blink, once fast followed by a long pause, to indicate a past alarm
condition.
4
The KEYPAD can monitor a vehicle being started by remote starter. To indicate that the
vehicle is running, the red LED associated with the vehicle’s zone will flash, the car running
(car icon) amber LED will be illuminated, and piezo will beep every 4 seconds. The
KEYPAD will reset after 30 minutes or when the corresponding zone button is pressed.
5
The KEYPAD may be powered by a 12v adapter, from a home or business an alarm security
panel, or a 9v battery. If the receiver is powered by the 9v battery, the output relays will not
be activated.
PROGRAMMING THE KEYPAD VC 100
To program the receiver
1.
Each KEYPAD zone must be programmed to the DISABLER.
2.
Press and hold the zone button you wish to assign to the vehicle. 4 seconds later, the
red zone LED will turn off.
3.
Release the button. The red zone LED will flash quickly to indicate that you have
entered programming mode.
4.
Within 128 seconds, set DISABLER into alarm. The KEYPAD will beep to indicate
that the KEYPAD has been programmed.
To erase all codes
1
Press and hold the KEYPAD power key for 8 seconds. The KEYPAD will beep to
confirm that all codes have been erased.
Summary of Contents for VC 1000
Page 7: ...7...
