USER MANUAL
3
Chapter 2 NVR Connection
2.1HDD Installation
Caution: Please do not
take out hard drive when NVR is running!
HDD Installation:
(1) Cut power firstly, and then remove screws on both sides and rear panel and open NVR
upper cover.
(2) Connect HDD data cable and power cable to the main board. Install the HDD and fix it
on the bracket and then connect the HDD power cable and data cable.
(3) Put the upper cover back carefully
Note: If user requires higher performance HDD, it is strongly recommended to use hard
drive for security.
2.2Web Camera and Monitor Connection
Transmit signals of web camera to NVR by the network cable and connect VGA port
and HDMI port for output (Refer to section 2.2 Rear Panel). Refer to Chapter 7 System
Connection Diagram.
2.3Power Supply Connection
Please use attached power adapter to connect NVR. Before power on, make sure
network port
is
well connected.
Chapter 3 NVR Boot up
3.1 System Initialization
After connecting the power cable of NVR to wall outlet and pressing the power button, you
will enter into the NVR system initializing screen shown as Picture3-1.
Picture3-1
3.2 Startup Wizard
After NVR startup is completed, the startup wizard will be displayed. If you do not want
to make any setting, you may click “Don't show this window next time” to cancel, as shown
Note
：
The illustration in the user
manual may not be the same as the
menu interface in your monitor. All
the illustrations are for users’
reference.
Summary of Contents for 16835
Page 2: ......
Page 26: ...USER MANUAL 21 Picture 4 37 ...
