Page 3 / 5
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENS”
selector located on the right side of the sensor head. (See Fig.5)
● Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to
achieve desired performance.
● Approximate range for each setting: 70 ft. (H), 50 ft. (M), 30 ft. (L).
Choose a mode by rotating the switch on the bottom of the sensor of the
fixture. (See Fig.5)
22012
6
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 4
1. Gently grasp the light heads and tilt them up or down, left or right to
adjust the light coverage area. Keep the light heads at least 1˝ (25mm)
away from the sensor.(See Fig. 4)
2. Keep the light heads 30˚ below horizontal to avoid water damage and
electrical shock.
Fig. 2
Fig. 3
Adjusting the Light Head:
Fig. 5
Auto
1min
Test
30s
M
L
H
3min
Off
MODE
SENS
TIME
Custom
PC
Modes
of Motion Sensor
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. TEST MODE (daytime and nighttime operation.)
●
●
3
. OFF MODE (nighttime operation only)
●
●
●
●
4
. AUTO MODE (nighttime operation only)
●
●
●
2
. PC MODE (nighttime operation only)
●
Slide the Time switch
to
the “Test” position.
The light turns to high-level brightness (5000K) when motion is detected. Then it reverts back to low-level brightness
and CCT color 2700K as per setting about 5 seconds after motion is no longer detected.
In "PC" mode, the light turns on at full brightness at dusk and remains on until dawn.
Select "OFF" on mode switch, slide the Time Delay knob to the desired shut-off delay time (30s/1min/3min).
At dusk, the light will remain off, the light will turn on to high-level brightness (at 5000K) whenever
motion is detected, and stays on as long as motion continues.
When the motion is no longer detected, it will remain on for the predetermined shut-off delay time you set
(30s/1min/3min), and then will turn off automatically.
The light will not turn on if motion is detected after dawn.
Select "AUTO" on mode switch, slide the Time switch to the desired shut-off delay time setting
(30s/1min/3min).
At dusk, the light turns on to low-level brightness 30% (2700K). When motion is detected, the light turns to full
brightness (5000K) and stays on as long as motion continues.
When the motion is no longer detected, the light will remain on at full brightness (5000K), for the
predetermined time you set (30s/1min/3min), and then automatically switch back to low-level brightness
30% (2700K)
.
●
At dawn, the light turns off automatically.
