Choose a mode by rotating the switch on the bottom of the sensor of the fixture. (See Fig.4)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. Switch Control Mode
(
No network,No Linkage)
● In "Switch Control"Mode,the light turn on 100% brightness and pre-selected CCT color(2700K~5000K).
● In "Switch Control"Mode,turn the wall switch “OFF" then turn it "ON" twice within 3 seconds,the light switch 100%
brightness to 30% brightness and pre-selected CCT color(2700k~5000k).To shift back 100% brightness ,turn on
"OFF" and "ON" within 3 seconds again.
● Power off for 5 seconds,then turn on the light,which will return to 100% brightness.
2. Motion Link Mode
● In "Motion Link" Mode,the light will be on 30% brightness and 2700k CCT color.
When the light receive the motion signal: In daytine,the Motion light will turn off due to the Photo sensor, and also
send a signal to motion link mode light for turning off.
Dusk Early Evening: Receive Motion Light signal and turn on the light (Low Level 30% 2700K CCT).
Motion Detection: Receive Motion Light signal and turn on the light (High Levek 100% 5000K CCT).
Dawn Morning: Receive Motion Light signal and turn off the light (perform same as motion light).
3. Not Link
● Press and hold the Link button on the body of light for 3 seconds,the light will flash 3 times to exit linkage.
● In RF Link State,shift the switch from Motion Link Mode to Switch Control Mode,the light will return to Switch
Control function.
Page 2 / 4
Installation Steps
Turn off the power at fuse or circuit box.
Turn on the power at the main fuse or circuit breaker box.
Adjusting the Light Head:
1. Gently grasp the light heads and tilt them up or down, left or right to
adjust the light coverage area. Keep the light heads at least 1˝ (25mm)
away from the sensor.(See Fig. 4)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and
electrical shock.
Fig. 4
1. The fixture mounting bracket is pre-assembled on the light fixture. Unscrew both the decorative cover and the fixture
mounting screw in order to remove the mounting bracket.
2. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using two
mounting screws that best fit the outlet box. Mounting bracket should sit flush against wall surface when secured.
(Choose one matching pair of suitable mounting screws from the 3 pairs provided).
3. Pull out the source wires from the outlet box.Connect the black wire from the outlet box to the "L" interface of the
terminal station on the mounting bracket. Connect the white wire from the outlet box to the "N" interface of the terminal
station on the mounting bracket. Carefully tuck the wires back into the outlet box.
4. Place mounting bracket against the outlet box, insert the mounting bracket screw through the mounting bracket hole,
thread mounting bracket screw into the center hole of the mounting strap. Tighten the mounting bracket screw securely.
5. Attach the backplate of the light fixture to the mounting fixture mounting screw. Then push the decorative cover firmly
into the fixture mounting screw hole on the light fixture.
6. With silicone caulking compound, caulk completely around where the back plate meets the wall surface.
CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from
seeping into the outlet box.
211221
