Customization Options:
Shut-off Delay
● The shut-off delay is the length of time the light will stay at brightness after motion has ceased to be detected.
● You can set the shut-off delay by rotating the delay time knob arrow so it points to the desired time setting within
“TIME” range. To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay, turn the
knob counterclockwise.
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. You may wish to
make adjustments when the season changes.
For best performance, gently clean the lens with a soft
cloth every 1 or 2 months to assure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 70 feet at 77 degrees
Fahrenheit. (See Fig.7)
3. The sensor detects movement across a detection range
of 240 degrees. (See Fig.8)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.9)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
Page 5 / 7
211221
5'
8.0'
12.0'
70'
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
or eave; otherwise, the detection distance may
be limited.
Fig.7
Fig. 8
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig.9
240
°
b. Motion Detect Linking
When the Motion Sensor detects
●
In "Auto" mode, the lamp sends out a comprehensive signal to all the linked lamps to automatically switch to
High-Level brightness (5000K) and remains on for predetermined time you set (30s/1min/3min).
●
In "3H" or "Custom" mode,
1) During the start of "3H" or "Custom" mode, the lamp will remain High-Level brightness and turn off the motion
sensor until 3 hours or the custom set time is up.
2) Once the "3H" or "Custom" set time is up, the lamp will turn on motion sensor and switch to "Auto" mode where
the lamp sends out a comprehensive signal to all the linked lamps to automatically switch to High-Level
brightness (5000K) and remains on for predetermined time you set (30s/1min/3min).
When the Photo Sensor detects that the ambient brightness is greater than the LUX set value,
●
A comprehensive signal from the volunteers to inform all the Linking lamps to turn off automatically.
Unlink the unit from the Link Group
Press and hold the Link button on the sensor head for 3 seconds, the light will flash 3 times to confirm reset and remove
from the Link Group.
All lights will need to be reset before setup the Link Group.
Strongly recommended to set all the linked lights to the same MODE to avoid any confusion of function error.
7. Manual Override (nighttime operation only)
● To temporarily override the settings in “AUTO” or “3H” mode for on-demand continuous high-level brightness at
night, turn the wall switch “OFF” then turn it “ON” twice within 3 seconds, the light remains on all night long.
To shift back to “AUTO” or “3H” mode, turn the wall switch “OFF” then turn it “ON” twice within 3 seconds again.
(See Fig.7)
● The light turns off automatically at dawn.
Note: When light units are linked, the Manual Override action is also linked when MODE settings are in
Auto or 3H.
